[Hot Toys] Spider-Man 3: Spider-Man 1/6th scale - LANÇADO!!!

My english isn't perfect, so it's kinda hard for me to explain this, but here goes:

1. I used the web holding hands and ran the fishing line through both arms and tied a knot.

2. Then I took a small screwdriver to remove the bottom shoe covers. This reveals the cloth underneath.
Cloth has four holes on it and if you touch the heel, you will notice it is actully hollow.

3. So, I took a hard plastic tube (diameter 4mm), covered it with duck tape, to make it softer from the surface, so that it would stick to the holes better.
Then I just attached both feet together with the tubing.

4. Ran the fishing line round the tube many times over and tied knots to the fishing line all the way through to make it look more like the webbing in the comics.
And attached the line to a hook in the seeling.

So, my figure is actually supported by both, hands and feet. So there should be no worries about the wrist pegs popping off and Spidey taking a free fall... Hope this makes any sense?

007 escreveu:Muito bom, mas dessa maneira será necessário furar os pés do aranha.
Alguém se habilita?

007 escreveu:Muito bom, mas dessa maneira será necessário furar os pés do aranha.
Alguém se habilita?

The Legend escreveu:

007 escreveu:Muito bom, mas dessa maneira será necessário furar os pés do aranha.
Alguém se habilita?

Sem chance.

007 escreveu:Muito bom, mas dessa maneira será necessário furar os pés do aranha.
Alguém se habilita?

007 escreveu:Muito bom, mas dessa maneira será necessário furar os pés do aranha.
Alguém se habilita?

Trunks68 escreveu:

007 escreveu:Muito bom, mas dessa maneira será necessário furar os pés do aranha.
Alguém se habilita?

E se colar uma fita dupla face nos pés?